On Friday afternoon, Nov. 13, 2026, the FAA issued a nationwide ground stop. According to the FAA, the technical issue started around 3:30 p.m. and air traffic resumed at 8:15 p.m. The FAA stated that the halt to flights was the largest since September 11, 2001. The FAA said that approximately 3,500 planes were airborne when the stop was issued, and each plane landed safely. The disruptions on the ground were significant. According to the FAA, there were approximately 12,462 cancellations of flights on Friday. However, the FAA noted that not all cancellations were caused by the ground stop.
FAA Administrator Bryan Bedford and Transportation Secretary Sean Duffy have stated that they believe the disruption was not a result of a cyberattack.
What Officials Say Happened
According to the FAA, the legacy equipment of the FAA became unstable because data flooded its network at a rate of 1,000 connection requests per four to five seconds. This disruption affected aircraft communications and radar feeds. Instability affected 17 of the FAA’s 22 en route air traffic control centers and several terminal radar facilities.
The initial investigation points to two specific sites: a radar facility located in Amarillo, TX and a radio communication facility located in El Dorado, AR. L3 Harris, who provides services for the FAA’s networks, had been performing maintenance and upgrading a router at the El Dorado location. After L3 Harris disconnected access to these two locations, the FAA’s network returned to normal operation.
Transportation Secretary Sean Duffy stated that the El Dorado upgrade involved switching from copper wiring to fiber optics and that he believes the installation or router may have been responsible for the instability.
Both routers are currently being evaluated at an L3 Harris laboratory in Florida.
What Changes Are Being Implemented by the FAA?
The FAA says it disabled the broadcasting function on all of the new routers, then on about 60 similar routers elsewhere in the system, as a precaution. It also said maintenance at major facilities is normally done at night, when traffic is lighter, and that after Friday it will reevaluate when replacement and maintenance work takes place.
Duffy said about 30 percent of the copper has yet to be replaced, and officials are working to identify where it is. Bedford cautioned that the aging technology “will continue to break until we replace it.”
What Everyday Users Can Learn
You can learn one key lesson from the FAA’s experience. A single errant device can create chaos throughout entire networks of devices connected together. Smart plugs, cameras and routers can slow down or take down every device attached to your home network if they are not functioning properly. If your Internet suddenly stops working immediately after adding some type of new device to your home network try unplugging the new device first.
Before attaching a new device to your network verify its functionality through testing:
- Update its firmware prior to plugging it into your existing network.
- Update its default password prior to connecting it to your existing network.
- Disable all unnecessary functions (such as remote administration).
- Then test it separately (using a guest network or on a stand-alone computer) before integrating it into your main network.
Change one thing at a time. If you replace your router, mesh nodes and smart home hub in one afternoon, you will never know which one caused the problem.
Keep the old equipment until the new is proven. Do not box up your old router, phone or computer the same day you set up the new one. Keep it ready for at least a week.
Updates go wrong at the worst moments. Avoid updating your router the night before a work deadline, a video interview or a trip. Pick a quiet weekend.
Know what old technology you still have. Officials are still working to find the remaining copper. Make a simple list of your devices, their age and whether they still get security updates.
Test after every change. Check that WiFi reaches every room, that your printer and smart TV connect, and that your backup still runs. Problems found on day one are far easier to fix than those found on day thirty.
A Simple Upgrade Checklist
Back up first. Change one thing at a time. Keep the old device running until the new one is proven. Pick a quiet time. Test everything afterward.
Moving from copper to fiber is the right goal. The lesson for the rest of us is that how and when you make a change matters as much as the change itself.
Stay safe out there, and I will see you next week!
Feeling lost in the digital world? Dr. Tom is here to help!
References
- Federal Aviation Administration. “Nationwide Ground Stop: Questions and Answers.” November 15, 2026. https://www.faa.gov/newsroom
- CNBC. “DOT Sec. Duffy Ties Router in Southern Arkansas to Issues That Led to Nationwide Ground Stop.” Published November 14, 2026, updated November 15, 2026. https://www.cnbc.com/2026/11/14/faa-ground-stop-flights-resume-delays.html
- NPR. “FAA Blames Friday’s Ground Stop on ‘Equipment Issue’ During Telecoms Network Upgrade.” November 14, 2026. https://www.npr.org/2026/11/14/nx-s1-6040952/faa-ground-stop-airplane-travel
- CNN. “What We Know About the Cause of the Nationwide FAA Ground Stop.” Kaanita Iyer. November 2026. https://www.cnn.com/2026/11/14/politics/faa-ground-stop-what-we-know
- Federal Aviation Administration. “Nationwide Ground Stop: Questions and Answers.” FAA Newsroom, November 2026. https://www.faa.gov/newsroom/nationwide-ground-stop-questions-and-answers

Sign up here to receive the Tega Cay Sun "day" Spectator every Sunday morning with all the news from the week directly to your inbox
Thomas Hyslip lives in Tega Cay with his wife and daughter. After 27 years in the U.S. Army and Federal Law Enforcement, he retired to pursue his passion for teaching. Tom is now an Associate Professor of Instruction at the University of South Florida. In 2 short years he has won 10 awards from the South Carolina Press Association, including first place in column writing, education beat reporting and best podcast.



